EVOLUTION-MANAGER

Edit File: radiusclient.conf

# RADIUS settings # The name to be used to identify this NAS (server). If set it will # be used in NAS-Identifier field and will override any such setting # by the application. # #nas-identifier my-server-name # Override the IP (or IPv6) address of the NAS. #nas-ip 10.100.5.3 #nas-ip ::1 # RADIUS server to use for authentication requests. # optionally you can specify a the port number on which is remote # RADIUS listens separated by a colon from the hostname. if # no port is specified /etc/services is consulted of the radius # service. if this fails also a compiled in default is used. # For IPv6 addresses use the '[IPv6]:port:secret' format, or # simply '[IPv6]'. You may specify more than a single server # in a comma-separated list. # authserver localhost #authserver 127.1.1.1:9999,172.17.0.1 # RADIUS server to use for accouting requests. All that is # written for authserver applies, in acctserver as well. # acctserver localhost # File holding shared secrets used for the communication # between the RADIUS client and server. When multiple # server servers /etc/radcli/servers # Dictionary of allowed attributes and values. That depends # heavily on the features of your server. A default dictionary # is installed in /usr/share/radcli/dictionary dictionary /etc/radcli/dictionary # default authentication realm to append to all usernames if no # realm was explicitly specified by the user # the radiusd directly form Livingston doesnt use any realms, so leave # it blank then default_realm # time to wait for a reply from the RADIUS server radius_timeout 10 # resend request this many times before trying the next server radius_retries 3 # local address from which radius packets have to be sent bindaddr * # Transport Protocol Support # Available options - 'tcp', 'udp', 'tls' and 'dtls'. # If commented out, udp will be used. #serv-type udp # Namespace in which all sockets of Radcli are to be opened. This is effectively same as the # Radcli existing on that namespace. # If commented out, the default existing Namespace will be used. #namespace namespace-name # Support for IPv6 non-temporary address support. This is an IPv6-only option # and is valid only when IPv6 Privacy Extensions are enabled in system. # If this option is set to "true", the radius packets will be sent with the # IPv6 Global address and will not use the temporary adresses. If commented # out, temporary IPv6 addresses will be used as source address for the packets # sent. #use-public-addr true # To enable verbose debugging messages in syslog, enable the following #clientdebug 1